What to do if Flex innovations Mamba 60E+ Super PNP motor turns in the wrong direction?
If the motor is turning in the wrong direction, it is likely that the three motor wires are connected incorrectly to the ESC. To resolve this, swap any two of the motor wires.
Why Flex innovations Mamba 60E+ Super PNP motor is nonresponsive but ESC initialization tones are audible?
If the motor is nonresponsive but you can hear the ESC initialization tones, it could be due to a couple of reasons. First, the throttle might not be at idle, or the throttle trim might be too high. Try lowering the throttle stick and trim completely. If that doesn't work, make sure the sub-trim and travel adjust are properly set in the radio's programming. Another possibility is that the throttle channel is reversed. If this is the case, reverse the throttle channel in the radio programming.
What to do if Flex innovations Mamba 60E+ Super PNP motor is nonresponsive and no ESC initialization tones are audible?
If the motor is nonresponsive and there are no audible ESC initialization tones, the motor might be disconnected from the ESC. Ensure that all plugs are fully seated. Also, check the battery and plugs for any damage, and replace any damaged components found. Do not attempt repair.
General| Power System | Electric |
|---|---|
| Skill Level | Advanced |
| Weight | 2.5 kg |
| Motor | Potenza 60 |
| ESC | 80A with 8A SBEC |
| Battery | 6S 3300-5000mAh LiPo |
| Servos | High Torque Metal Gear |
| Radio System | 6 Channel |
| Construction | Composite and balsa wood |
To Next Page