Working with Banks – Play Mode
1. Press Mode Switch until you enter in BANK MODE: appears on the display for few milliseconds, it
means you entered in Bank A.
2. (from default configuration) appears on the display, it means you entered in Bank A with Preset 1
loaded.
3. Single Press of the footswitch to change the bank position. By default the Bank A has been programmed
with Preset 1, Preset 2, Preset 3 and Preset 4, so if you continue to single press the footswitch, on the
display will appear , , ,
4. Hold On the footswitch to change the Bank, when you reach the desired Bank, release the footswitch.
5. stands for Bank Save: it is a reserved Bank that lets you enter in Bank Saving Mode.
To Next Page
Loading...