FLEX ADM30
12
– The plug of the device must fit in the power
socket. Never modify the plug in any way.
Unmodified plugs and suitable power sockets
will reduce the risk of electric shock.
– Only use the charger in dry rooms and avoid
any contact with moisture and rain. The
ingress of water in the charger increases the
risk of electric shock.
– Keep the charger clean. Through
contamination there is a risk of electric shock.
– Never use the charger if cables, plugs or the
device itself are damaged from external
influence. Take the charger to the nearest
specialist workshop.
– Under no circumstances open the charger.
In the event of a fault, take it to a specialist
workshop.
Overview
1 Receiver lens
2 Laser discharge window
3 ON/OFF button/mode button
– Switches the power tool on and off.
– Changes the unit of measurement.
– Selects the measuring modes.
4 Display
5 Laser warning sign
6 Measurement button
Switches the laser beam ON or triggers the
measurement (depending on which
measuring mode is selected).
429.279_ADM30.book Seite 12 Freitag, 4. März 2016 8:03 08
To Next Page
Loading...
Need help?
General
