Flex ADM 30 User Manual

FLEX ADM30
14
NOTE
The battery is supplied partly charged only.
Before using the device for the first time, fully
charge the battery.
The most important operating steps are
explained at the end of these instructions on the
illustrated pages.
See from page 144.
Charging the battery .................................. 144
Switching the device on and off................. 146
Setting the unit of measurement ............... 148
Setting the measuring mode ..................... 150
Length measurement ................................ 152
Surface measurement .............................. 154
Continuous measurement ......................... 158
Checking the precision .............................. 162
Error message on the display
Error code Cause
➜ Remedy
001 The reflected laser beam is too intense.
➜ Do not aim at highly reflective surfaces;
if required cover (e.g. with paper).
002
Measurement range exceeded.
➜ Only carry
out measurements in a range from 0.2-30 m.
003 The target reflects the laser beam poorly.
➜ Aim at a different target; cover if necessary
(e.g. with white paper).
004 Temperature too high.
➜ Wait until the device
has reached operating temperature
(0 °C ... 40 °C).
005 Temperature is too low.
➜ Wait until the
device has reached operating temperature
(0 °C ... 40 °C).
006
Battery is too weak.
➜ Charge the battery.
007 Strong vibrations or quick movement while
taking the measurement.
➜ Do not move the
measuring instrument during use.
429.279_ADM30.book Seite 14 Freitag, 4. März 2016 8:03 08

Flex ADM 30 Specifications

General

Type	Digital Multimeter
Continuity	Yes
Operating Temperature	0°C - 40°C
Battery Life	Up to 200 hours
DC Voltage Range	0.1V - 1000V