CS 40 WET
14
Loosen the 0-45° locking knob.
Tilt the body of saw until the required angle is reached.
Tighten the locking knob to secure the base plate.
Switch on and off
The main switch requires two actions to turn the tool on. The tool can only be
put into service if the handle is firmly grasped and both buttons are
depressed. The main switch automatically locks in the “OFF” position when
the trigger is released, preventing any unintentional operation.
Locking the switch:
Press and hold down trigger switch (1).
Press lock-off button (2) to lock the switch.
Switch off the machine:
Press and release the trigger switch.
To Next Page
Loading...
