Flex CS 40 WET User Manual

CS 40 WET
15
Operating instructions
Tile cutting
CAUTION!
Always open the water valve before you start cutting the tile material with the
blade supplied with this saw or other wet-cutting blades. The volume of water
flow can be adjusted with the water valve.

Mark the desired cutting line on the work piece surface, and ensure that
the tile material is securely clamped or stationary and horizontal.

Align the cutting line with the 0° standard line.

Hold the tool firmly and turn the tool on. Don’t allow the blade to contact
the material until it has attained full speed.

If using the blade supplied with this saw or another wet-cutting blade,
open the water valve to allow water to flow onto the blade.

Slowly and smoothly move the tool forward to cut, keeping the base plate
flat on the surface.

Keep the tile saw moving forward smoothly and evenly until the cut is
complete.
Maintenance and care
WARNING!
Before performing any work on the electric power tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and ventilation slots. Frequency of cleaning is
dependent on the material and duration of use.
Regularly blow out the housing interior and motor with dry compressed air.
Carbon brushes

Flex CS 40 WET Specifications

General

Brand	Flex
Model	CS 40 WET
Category	Saw
Language	English