Flex CS 62 18.0-EC User Manual

CS 62 18.0-EC
22
 Insert connection (1.).
 Secure suction hose with adapter on
connection (2.).
 Connect extraction hose to the dust
extraction system.
Follow the operating instructions
for the dust extraction system!
Check the attachment!
Setting the cutting depth
NOTE
To ensure optimum cutting results, the cutting
depth should be 2–5 mm greater than the
material thickness to be cut.
WARNING!
Remove the battery before carrying out any
work on the power tool.
 Loosen toggle screw of the cutting
depth setting.
 Set required cutting depth on the scale.
 Tighten toggle screw.
Setting the mitre angle
NOTE
In the case of mitre cuts, the cutting depth
is less than the value displayed on the scale
for the cutting depth.
WARNING!
Remove the battery before carrying out any
work on the power tool.
 Loosen the T-screws (1.).
 Set required mitre angle with the aid
of the scale (2.).
 Tighten the T-screws (3.).
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.

Flex CS 62 18.0-EC Specifications

General

Voltage	18 V
Blade Diameter	165 mm
Cutting Depth at 90°	57 mm
Saw Blade Bore	20 mm
Bevel Range	0° to 50°