Flexit Nordic CL3 - 4. Cleaning and maintenance; 4.1. CLEANING THE FANS

9
NORDIC CL3
4. Cleaning and maintenance
!
Before opening the door: Turn the
heat off and allow the fans to run
for three minutes to remove hot
air. Unplug the unit and wait two
minutes before opening the door.
4.1. CLEANING THE FANS
The fan in a unit connected to a kitchen hood should be
inspected once a year. For a fan in a unit that is not con-
nected to a kitchen hood, inspection every three years
LVVXɝFLHQW&OHDQWKHIDQEODGHVZLWKDJUHDVHVROYHQW
on a cloth (e.g. methylated spirits) and compressed air if
possible.
NB: Take care that the motor is not exposed to water.
To avoid mixing the fans up, it is
best to disconnect one fan at a
time.
i
!
DANGER! The fan may fall out
when the fastening screws are
loosened.
TIP: You need a T20
To take out the fan:
1. Undo the screws in the electric cover and take the
FRYHUR΍
2. Disconnect the electric quick-release contact in the
electrical compartment by pressing in at the same
time as pulling the contact apart.
3. Pull the cable bushings out of the grooves so that
the cable with a quick-release contact comes too.
1
2
3