Flipper Two-Device Universal - Code Search Setup; Initiating Code Search; Identifying and Confirming Matches

CODE SEARCH
Start with the TV and STB on. Code search sends codes from
the database to your TV or STB to search for a match. When the
device turns off, a match is found.
1. Press and hold the device you want to search (TV or STB) till
light solid, then enter code for region;
a. US / Canada: enter 962;
b. UK / EU / AUS / NZ enter 961;
2. Press and release On/Off. The light ashes, sending 15 codes
to the TV;
3. Either: the device turns off, or the light turns solid. If it turns
off, then there is a match in the batch:
a. If the TV turns off, wait till light stops ashing. Then
slowly press and release the CH - (down) to send one
code at a time until the TV turns back on.
b. If the light turns solid (TV does not turn off), then press
On/Off again to send another batch.
4. Once the TV turns back on, press and release TV (or STB).
Test other functions.
Note: If your home region did not turn up a match, try the other
region. Many devices share codes.
8