FLIR EX Series Getting Started Guide

1 EN-US English
1.1 Quick Start Guide
1.1.1 Procedure
Follow this procedure:
1. Charge the battery. You can do this in three different ways:
• Charge the battery using the Flir stand-alone battery charger.
• Charge the battery using the Flir power supply.
• Charge the battery using a USB cable connected to a computer.
Note
Charging the camera using a USB cable connected to a computer
takes considerably longer than using the Flir power supply or the Flir
stand-alone battery charger.
2. Push the On/off button
to turn on the camera.
3. Open the lens cap by pushing the lens cap lever.
4. Aim the camera toward your target of interest.
5. Pull the trigger to save an image.
(Optional steps)
6. Install Flir Tools on your computer.
7. Start Flir Tools.
8. Connect the camera to your computer, using the USB cable.
9. Import the images into Flir Tools.
10. Create a PDF report in Flir Tools.
#T559815; r. AA/ 7404/7404; en-US 1

FLIR EX Series Specifications

General

Brand	FLIR
Model	EX Series
Category	Thermographic Cameras
Language	English