For two-camera probe, press the button to toggle between the
side view and the front view camera lens.
• Press the button to take a picture.
• Press and hold down the button for 3 seconds to start/stop re-
cording a video.
Press the button to rotate the display 90°.
Press the buttons to increase/decrease the display resolution.
Press the buttons to increase/decrease the camera LED light
intensity.
Press and hold down the button for 5 seconds to switch on/off the
monitor.
• Press the buttons to navigate up/down in the setup menu.
• Press the
button to access the picture/video memory.
• Press the button to open the setup menu.
• Press the button to select the highlighted menu item.
Press the button to exit the setup menu.
4.1.2 Display icons
Indicates that a picture is being taken.
Indicates that a video is being recorded.
Indicates the battery voltage status.
To Next Page
Loading...
Need help?
General