Flite 2 Series - Inflating the Fliteboard AIR

21
Inflating the Fliteboard AIR
1 Twist the valve cap anti-clockwise to remove.
2 To inflate, push the central valve down.
3 Twist anti-clockwise to release.
4 The valve will pop up. This ensures the bladder will not deflate when
you remove the hose after inflation.
5 Connect pump hose to valve and inflate bladder to 15 – 16 PSI.
THIS IS IMPORTANT FOR OPTIMUM PERFORMANCE AND SAFETY.
6 Once inflated to 15 – 16 PSI, twist the pump hose anti-clockwise to
remove and re-fit the valve cover cap. When disconnecting the pump
hose, no air should escape from the valve. If the bladder deflates you
must release the central valve (see step 2) and re-inflate. Fliteboard
AIR is now inflated.
5
2
1
1
3
4
5
5