Flite 2 Series - Connect the fuselage tail; Connect the Wing

To Next Page

To Previous Page

Connect the fuselage tail

1 With the board upside down and the eFoil connected, take the

20cm long aluminium fuselage tail from the travel bag and insert into

the ﬁn under the propeller guard. Add a light cover of Tef-Gel to the

tail connection.

2 Add a thin layer of Tef-Gel from the tube supplied to the thread of the

supplied 12mm fastener bolt and carefully tighten using the hex key

using torque of 6 Nm.

Connect the Wing

1 Remove your front wing from the travel bag and from its wing cover

(if attached – depending on model).

2 Place the wing in position as shown.

3 Insert the 3 fasteners taking care to ensure the correct set is being

used for the particular wing model you are ﬁtting (Refer to page 15).

ALWAYS add Tef-Gel to the fasteners ﬁrst. The fasteners should

extend by approximately 6mm through the Wing when placed in the

countersunk holes.

4 Tighten the fasteners with the supplied hex key, ensuring the fasteners

are tight enough that the wing cannot move or wobble signiﬁcantly

during use. Use a torque of 6 Nm to tighten the fasteners.

TEF-GEL