Flite 2 Series - Connect Flitecell to Fliteboard

25
Connect Flitecell to Fliteboard
With the eFoil, fuselage tail and wings attached, it’s time to carefully
turn your board over so it stands on BOTH the front wing and nose
of the board.
1 Twist the Lid Latches and open the board Lid.
DO NOT OPEN LID WHILST IN THE WATER UNDER ANY CIRCUMSTANCES.
2 Take Flitecell by the handle and carefully lower it into the board cavity,
ensuring to move cables out of the way first. The warning label should
be facing up.
3 Connect the orange power cable to the orange power in Flitecell.
You will feel a secure click when properly engaged.
4 Connect the black power cable to the black power in Flitecell.
Flitecell is now connected.
2
5
6
2
5
6
2
5
6
2
5
6
BE CAREFUL NOT TO
DAMAGE THE BOARD SEAL
WHEN FITTING FLITECELL.
ANY KNICKS, CUTS OR
DAMAGE TO THE SEAL MAY
RESULT IN LEAKS.
BE CAREFUL NOT TO
RECONNECT FLITECELL
POWER CABLES, WITHIN
10 SECONDS OF
DISCONNECTION
TO AVOID A POSSIBLE ARC.