Flite 2 Series - Turning on Fliteboard

26
Turning on Fliteboard
1 Make certain nothing is caught in the seal. Carefully close the lid.
2 Twist and lock the two lid latches.
3 A few seconds after the lid is shut in position, you will hear a
‘beep beep beep’ which signifies that the Flitecell and board have
automatically turned on.
4 If the external board light is not active, open the lid and ensure the
power cables are properly connected, and there are lights on the
Flitecell indicating it is switched on.
5 Flitecell will automatically turn o 10 seconds after the lid is opened.
THE SEAL IS A CRITICAL COMPONENT. IF DAMAGED CONTACT
YOUR DEALER FOR A REPLACEMENT PART. NEVER RIDE THE BOARD
WITH A DAMAGED SEAL.
THE FLITECELL AND CABLES ARE WATER RESISTANT; HOWEVER,
ALWAYS KEEP FLITECELL, CABLES AND BOARD CAVITY DRY.
WATER, ESPECIALLY SALT WATER, CAN ACCELERATE AGING AND
CORROSION. IF YOUR BOARD LEAKS, CHECK SEALS, AND CLEAN
COMPONENTS CAREFULLY.
1
4
SEE PAGE 36 FOR PAIRING
FLITE CONTROLLER