Flo-Dynamics
®
TSD450™ III. Operating Instructions
Operations Manual
Printed in the U.S.A. for Flo-Dynamics ®
13
Connect red and gray service
hoses to chrome manifold.
Insert nylon tube down dipstick
tube the same length as the
dipstick, being cautious not to
insert too far.
Use the yellow ▲▼ arrow
keys to select the desired
amount to be exchanged. Press
the green button to proceed.
cleaning mode to circulate
additives through the vehicle’s
transmission.
Press 3 for 10 Minute Cleaning
Press the Green Button to
begin the exchange.
Start the vehicle’s engine when
the display prompts you to do
so. Then press the Green
Button to proceed.
Once the exchange is finished,
the screen will beep and display
“Complete”.
Add Transmission Treatment.
See “Adding Chemicals”
section.
PERFORMING AN INLINE EXCHANGE
Press 1 for Inline Exchange.
Vehicles with Internal
Transmission Thermostats:
Before a transmission fluid
exchange service can be
performed, refer to O.E.
recommended procedure to
ensure transmission fluid flow
through transmission cooler.
To Next Page
Loading...
