1. Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
Read all the instructions before using this product.
Please keep up to date instructions throughout the product life cycle.
This document provides instructions to install the FLO Ultra lifting jig and should not
be used for any other product.
1. Under no circumstances will compliance with the information in this manual
relieve the installer of their responsibility to comply with all applicable codes or
safety standards.
2. Reasonable efforts have been made to ensure that the specifications and
other information contained in this guide are accurate and complete at the
time of publication. However, specifications and other information contained
in this manual are subject to change at any time without notice.
3. FLO cannot be held responsible for any damage that may occur resulting from
custom installations not described in this document.
4. If for any reason it is not possible to install the FLO Ultra lifting jig according to
the procedures provided in this guide, the installer should contact the FLO
team.
5. Connect the power supply of the charging station with conductors rated for
usage at a temperature of at least 167 °F (75 °C).
6. Any modification done to the lifting jig is forbidden without express written
permission from FLO.
7. Handle parts with care since they can be sharp-edged. Always use safety
glasses, safety shoes and protection gloves when unpacking and installing the
FLO Ultra lifting jig.
3
To Next Page
Loading...