Floe 511-00832-00 User Manual

- 3/4” SOCKET
- 3/4” WRENCH
- 11/32” WRENCH
- PHILLIPS SCREW DRIVER
- TORQUE WRENCH
TOOLS REQUIRED
All material © 2018 FLOE International, Inc.
Unauthorized reproduction is strictly prohibited.
Specications subject to change without notice.
INSTRUCTION P/N 611-00832-00
ISSUED: 3/22/17 REVISED 5/18
FLOE WIRELESS REMOTE
ASSEMBLY INSTRUCTIONS
KIT P/N 511-00832-00

Floe 511-00832-00 Specifications

General

Brand	Floe
Model	511-00832-00
Category	Remote Control
Language	English

Summary

Assembly Instructions

Step 1: Assemble Mast Mount Bracket

Assemble the mast mount bracket using a 1/2" washer and bolts. Start 1/2" nuts but do not tighten until step #4.

Step 2: Assemble Bracket Onto Leg Insert

Assemble the mast mount bracket onto the leg insert. Remove and reinstall the leg cap after completion.

Step 3: Assemble Receiver Onto Mast

Assemble the receiver onto the mast and thread the antenna. Secure using screws and an #8/ Nylock nut.

Step 4: Connect Wires Together

Secure wires to the lift frame with Velcro. Feed the wire through the bracket and connect the wires.

Reprogramming Receiver To Transmitter Fob

Prepare Receiver for Reprogramming

Follow procedure A, B, and C to prepare the receiver for reprogramming, involving mast adjustment and component removal.

Erase Current Settings

Press and hold the 'Learn Switch' for 15 seconds to de-program all existing transmitter fobs.

Reprogram Remote Receiver

Reprogram the receiver by pressing the 'Learn Switch' and then the specific button on the fob (DOWN, UP, FLOODLIGHT).

Reassemble and Reinstall Mast

Reassembly Procedure

Ensure the circuit board slides into channels, the antenna hole lines up, and the base is fully seated during reassembly.

Alternate Reprogramming Method

Magnet Reprogramming

Place a magnet on the receiver's upper right side and hold any remote button until a relay click is heard.