FLORABEST FHT 600 A1 User Manual (English)

Other manuals for FLORABEST FHT 600 A1

Operation Manual82 pages

Translation Of Original Operation Manual70 pages

Questions and Answers:

C
csimpsonAug 2, 2025
What to do if my FLORABEST FHT 600 A1 Trimmer does not start?
- J
  Jennifer McdowellAug 2, 2025
  If your FLORABEST Trimmer isn't starting, there are several potential causes. First, ensure that the mains voltage is active by checking the plug socket, cable, line, and plug. If any of these are faulty, have them repaired by a qualified electrician. Also, the On/Off switch might be defective, in which case you should seek repair at a service center. Other potential issues are worn carbon brushes or a defective motor.
Q
qharrisAug 10, 2025
Why does my FLORABEST FHT 600 A1 run with interruptions?
- S
  Sarah PriceAug 10, 2025
  If your FLORABEST Trimmer runs with interruptions, it could be due to a damaged power cable. Check the cable and have it replaced by a service center if necessary. Another cause might be a loose internal electrical connection, which requires repair by a service center. The On/Off switch might also be defective.
J
Jeremy AyalaAug 17, 2025
How to fix hot blades on FLORABEST FHT 600 A1?
- J
  Jennifer JonesAug 17, 2025
  If the blades on your FLORABEST Trimmer are getting hot, it could be because they are blunt. You should have the blades sharpened or replaced at a service center. Notched blades can also cause overheating, so have them checked or replaced at a service center as well. Insufficient lubrication can also lead to excessive friction; try oiling the blades.
B
bellanneAug 26, 2025
How to fix overheated blades on FLORABEST Trimmer?
- K
  Kevin SolisAug 26, 2025
  If the blades of your FLORABEST Trimmer become hot, it could be due to several reasons. The blades might be blunt, in which case you should have them sharpened or replaced by a Service Centre. Alternatively, the blades might be notched, requiring them to be checked or replaced by a Service Centre. Lastly, too much friction due to lack of lubrication can cause the blades to heat up; try oiling the blades.