How to fix Floureon Two-Way Radio with no electrical source?
If your Floureon Two-Way Radio has no electrical source, it could be due to an exhausted battery. Try replacing or recharging the battery. Another possibility is that the battery is installed incorrectly. Remove the battery and reinstall it, making sure it's properly aligned.
What to do if other radios cannot receive TX signals from Floureon Two-Way Radio?
If other radios cannot receive the TX signals from your Floureon Two-Way Radio, or if the signals are received at a low volume, first ensure that the volume knob is set to the highest level. If the problem persists, the microphone may be damaged, and you should consider having it checked by a local dealer.
Why Floureon A5 Two-Way Radio cannot communicate with transceivers of the same group?
If you are unable to communicate with transceivers in the same group using your Floureon Two-Way Radio, make sure that the QT/DQT settings are the same for all devices. Also, consider that the distance between the transceivers might be too far, exceeding the radio's range.
Why operating time of Floureon A5 Two-Way Radio is short?
If the operating time of your Floureon Two-Way Radio becomes short even when the battery is fully charged, the best solution is to replace the battery.
What to do if I hear another group on my Floureon A5 Two-Way Radio?
If you are hearing the voice of another group on your Floureon Two-Way Radio, try changing all QT/DQT settings for your group.
Why is there always noise on my Floureon Two-Way Radio?
If noise is always heard on your Floureon Two-Way Radio, it might be because the distance is outside of the radio's range. Try turning on the radio in a nearer location and try again.
Charger self-testing process and indicator behavior during power-up.
Explanation of charging indicator lights and states for battery charging.
Step-by-step guide for battery installation and removal from the radio.
Instructions for connecting an external headset to the mic/speaker jack.
How to use the scan function for finding active channels and signals.
Required operating system and hardware for PC programming.
Steps to install the necessary driver for the programming cable.
Instructions for installing the programming software on the computer.
Guide to operating the PC programming software for configuration.
A table listing common operational troubles and their solutions.
General technical parameters of the radio, including frequency and voltage.
Technical specifications related to the radio's receiver performance.
Technical specifications related to the radio's transmitter performance.
General| Frequency Range | 400-470 MHz |
|---|---|
| Number of Channels | 16 |
| Operating Voltage | 3.7V |
| Battery Capacity | 1500mAh |
| Battery Type | Li-ion |
To Next Page
