Flow Focus - Printing Operations; 2.1 Setup for Printing

3
Set up2.1
• To print an object on the Focus 3D printer, first
generate a g-code using a slicing software. For
more instructions how to use slicing software,
go to page page 8 in FAQ section
• Upload your file on the Focus 3D printer via
WiFi in the following steps:
1. Connect your PC or Laptop to the WiFi
network of the Focus (byFlow_[serialnumber];
password: withflow);
2. Open a browser on your computer and go
to: http://192.168.0.1/ in the address bar;
3. Click on upload file and select the g-code
that you want to print. When the file is
uploaded to the printer, you will get a popup
that the uploading was successful.
WARNING! Don’t upload files while the
3D printer is printing!
• Once you uploaded your file(s), you can
disconnect the byFlow WiFi-network.
Printing2