JetFlow Relay
User Instruction – AIIOM000287
7
Use caution to avoid pinch point hazards during service and
repair operations.
CAUTION: Before returning products to FLOWSERVE for
repair or service, provide a certificate to FLOWSERVE which
confirms that the product has been decontaminated and is
clean; FLOWSERVE will not accept deliveries if a certificate
is not provided (a form is available from FLOWSERVE).
Apart from the operating instructions and the necessary
accident prevention directives valid in the country of use,
follow all recognized regulations for safety and good
engineering practices.
3 PRE-INSTALLATION
3.1 Storage
It is mandatory to store the FLOWSERVE JetFlow in a clean,
dry environment. Prevent flooding of the equipment, including
rainwater, that can pool in packaging materials. Prevent dirt
or sand accumulation in the pneumatic ports and vents.
If FLOWSERVE products have been in storage for longer
periods, check them for corrosion or deterioration before
using these products. The end user is responsible for
providing fire protection for FLOWSERVE products.
3.2 Unpacking
While unpacking the JetFlow positioner unit, check the
packing list against the materials received. Each shipping
container includes a list describing the system and
accessories included.
In the event of shipping damage, contact the shipper
immediately. Should any problems arise, please contact a
FLOWSERVE Flow Control Division representative. Phone
numbers are at the back of the manual.
3.3 Pre-installation Inspection
When installing a JetFlow positioner assembly, check the
remote mount module, wiring and pneumatic connections are
secure.
If there is contamination in the unit, clean the JetFlow and
positioner gently with a soft damp cloth.
To Next Page
Loading...
General