Fluance RT82 - First Time Setup; Step One: Installing the Platter

Fluance RT82, RT83, RT84, RT85 User Manual
6
1. Remove the protective packaging and
ensure the turntable is placed on a
sturdy and level surface. Place the
platter onto the spindle located in the
middle of the turntable.
2. Place the motor pulley cap over the
motor pulley. Ensure the arrows are
aligned so that the motor pulley cap
is installed properly.
3. Lift the rubber belt and place it around
the motor pulley. Rotate the platter
several times to ensure the rubber belt
is secure and not twisted.
4. RT82/RT83: Place the turntable mat
on top of the platter. Make sure the
logo side is facing up
Note: RT84/RT85-Turntable mat is not included.
When using an acrylic platter a turntable mat is not
required.
Turntable Mat
Platter
Motor Pulley Cap
Spindle
Motor Pulley
First Time Setup
Step One: Installing the Platter