3
GENERAL CARE
SPYDR 2 system is passively cooled with zero moving components. They are
designed for harsh environments and years of maintenance-free performance.
Some basic care will keep your system operating at peak performance cycle-
after-cycle.
• Natural convection removes heat away from the heatsink. In order for
the system to properly cool itself, at least one inch of space is required
between the console and the roof of your grow area. Failure to do so may
shorten the fixture’s lifespan.
• To achieve the optimal lifespan and performance of your fixtures, routinely
check for and remove excess dust, debris, and mineral build up from
heatsink and LED array. Cleaning should always be done with the fixture
unplugged from its power source using low-pressure compressed air or
water to rinse away dirt from light bars.
• Never use a cloth to clean the diode array. Doing so can scratch or
compromise the integrity of the silicon seal, or dislodge diodes entirely.
• To limit degradation, avoid touching the diodes with your hands, even in a
powered off state.
For detailed instructions for maintenance and cleaning,
please visit www.fluence.science/support-center/.
SPYDR 2 is a high-performance lighting system.
Do not touch while in operation.
PLEASE RECYCLE ALL PACKAGING MATERIAL
To Next Page
Loading...