14
WARNING
Risk of electrical shock.
To reduce the possibility
of serious injury,
always take the proper
precautions and unplug
the fixture before moving
or cleaning.
WARNING
Fixture and power supply are UL
8800 Wet Location rated but are
not designed to be submerged
in water. In the event that
the module or power supply
enclosure becomes submersed,
first disengage the circuit
breaker, then unplug submersed
components before proceeding
to remove from water.
CAUTION
To prevent eye damage,
avoid looking directly at
the unshielded LEDs.
CAUTION
LED and heat sink
surfaces may be hot.
Allow sufficient cooling
time before handling.
CAUTION
To reduce the risk of
overheating or fire,
never place operating
fixtures face down on
a flush surface. Always
allow for adequate
ventilation of fixtures
and power supplies.
ETL Rating: SPYDR 2 fixtures are rated suitable for wet locations. A “wet location” is defined as an interior or exterior location in which water or other liquids
may drip, splash or flow on or against the electrical components of a lighting fixture. SPYDR 2 Series fixtures and power supply are certified to meet UL standards
(ETL) from the Intertek safety consulting and certification company. Systems are cETL listed and are rated IP66 by IEC standard 60598-1.
CHEMICAL EXPOSURE PRECAUTION
Fluence lighting systems are designed to be resilient against crop protection products. Many chemicals used in the Commercial Horticultural Industry are
corrosive to electronic equipment. Care should be taken to ensure that only approved crop protection products, cleaning agents and/or other chemicals (e.g.,
pesticides, fungicides and insecticides) may come in contact with the luminaire. If the luminaire is accidentally exposed to a corrosive liquid or vapor (e.g.
VOC –Volatile Organic Compound and H2S – Hydrogen Sulfide) the luminaire must be rinsed with clean water as soon as possible. The product warranty will no
longer” apply if the product is repeatedly exposed or remains in the corrosive environment for a prolonged period. It is recommended the luminaires be removed
and protected from the corrosive environment during all periods of aggressive disinfection or sanitization of the facility. The product warranty will be void if the
product is repeatedly exposed to Sulfur.
To Next Page
Loading...