Power Quality Analyzer
Safety Information
3
• During operation, ensure the free circulation of air
around the instrument to prevent heat
accumulation inside the housing
• Refer to and comply with instructions in Users
Manual chapter "Transport and Storage" before
packing and transporting the Recorder
Note
Do not use the device for any other purpose than
the measuring of voltages and currents that are
within the specified ranges and categories,
including voltage to earth ground. Refer to the
Users Manual for detailed specifications.
Improper use shall void all warranties.
Electrical Connections
• Ensure that the protective earth ground
connectors for both the power lead and the
housing earth ground are connected according to
the instructions for the low-resistance unit earth
cable
• Ensure that the power and connecting cables, as
well as all accessories used in conjunction with
the device, are clean and in proper working order
• Install the Recorder so that its power cable is
accessible at all times and can easily be
disconnected. If this is not possible, a two-pole
circuit breaker with a nominal current (mentioned
in the documentation following), must be installed
in the power supply lines
• For hazardous voltage connection work, do not
work alone. Work in teams of at least two
persons
• Do not use the device if the housing or an
operating element is damaged
Permitted Accessories
• Use only the accessories supplied with the
Recorder or optional equipment specific to your
model
• Ensure that any third-party accessories used with
the Recorder conform to IEC 61010-031/-2-032
standard and are suitable for the respective
measuring voltage range
Risks during Recorder Operation
• Ensure that the connected devices work properly
To Next Page
Loading...
Need help?
General