Need help?Do you have a question about the Fluke 77 Series IV and is the answer not in the manual?
General| AC Voltage Range | 0.1 mV to 1000 V |
|---|---|
| DC Voltage Range | 0.1 mV to 1000 V |
| AC Current Range | 0.01 mA to 10 A |
| DC Current Range | 0.01 mA to 10 A |
| Resistance Range | 0.1 Ω to 50 MΩ |
| Frequency Range | 0.01 Hz to 100 kHz |
| Safety Rating | CAT III 1000 V, CAT IV 600 V |
| Continuity | Yes |
| Diode Test | Yes |
| Display | Digital |
| Battery Type | 9 V |
| Weight | 420 g |
| Capacitance Range | 1 nF to 9999 µF |
Essential safety guidelines to prevent electrical shock, fire, or injury during operation.
Common error codes and troubleshooting steps for meter issues.
Captures minimum, maximum, and average readings during measurement.
Holds the display until a new stable reading is detected.
Procedure for checking circuit continuity with the multimeter.
Procedure for testing diodes in various states (forward, reverse, open, short).
Procedure for safely measuring AC and DC current.
Procedure for measuring signal frequency using the multimeter.
Guidelines for safely replacing the battery and fuses with correct types.
Compliance with safety standards like IEC and measurement category ratings.
Overload protection and input impedance for voltage and capacitance measurements.
Overload protection and limits for mA and A current measurements.
To Next Page
