Flurida FDFM1JA01 - Troubleshootings; Unit does not work and the Power LED is not lit; Unit does not make ice; Unit does not dispense ice

15
24412 Main St. Suite 105, Carson, CA 90745
TROUBLESHOOTINGS
Complaint
Possible Causes
Response
Unit does not work
and the Power LED is
not lit
a. There is no power at outlet.
b. Power cord is unplugged.
c. Power cord is broken.
d. Control PCB is defective or
with wiring problems.
e. Display PCB is defective or
with wiring problems.
a. Check for outlet and breaker/fuse.
b. Plug in the power cord.
c. Call for service.
d. Call for service.
e. Call for service.
Unit does not make
ice
a. The ice maker is turned off.
b. Water Level red LED flashes
and the water reservoir is low.
c. Making Ice green LED
illuminates but unit has
dispensed all ice.
d. Cleaning LED flashes and
defrosting is required.
e. Water Level red LED
illuminates.
f. The water pump, water level
sensor, ice engine motor or
cooling system is defective.
a. Turn the ice maker on.
b. Fill the water reservoir with potable
water.
c. Use the Cleaning mode to melt
clumped ice.
d. Use the Cleaning mode to defrost.
e. Call for service.
f. Call for service.
Unit does not
dispense ice
a. There is no ice in the ice bin.
b. Ice is jammed in the ice bin.
c. Ice is stuck in the ice dispense
point
d. The ice bin auger or motor,
control PCB or display PCB is
defective.
a. See Unit does not make ice
b. Use Dispense Ice and Clean button
combination to break the jammed ice.
c. Use a spoon to remove the stuck ice.
d. Call for service.
Unit leaks water
a. The water reservoir is overfull.
b. The drip tray is overflow.
c. The water reservoir or tubing is
leaking.
d. The water level sensor is
defective.
a. Reduce the water fill.
b. Empty it.
c. Call for service.
d. Call for service.