Flurida FDFM1JA01 - Use of Dispenser; Display; Make Nuggets Button; Clean Button

6
6
i n f o @ f l u r i d a a p p l i a n c e s . c o m
USE OF DISPENSER
NOTE
Clean the unit once a week to prevent high water TDS and
hardness.
Descale the unit with citric acid once a month to prevent sediment
building up.
Sanitize the unit with chlorine bleach once a month to prevent
bacteria growing.
NOTE
Use potable water only.
Water TDS level must be 5~400 mg/L or PPM.
Water Hardness must be no greater than 10 grains/gal (180 mg/L).
Display
Make Nuggets Button
It can be used when the unit is not in the Cleaning mode.
 Press once to start making ice, the Making Ice LED flashes slowly while the
unit is currently making ice.
 Press and hold for 3 seconds to stop making ice, the Making Ice LED goes
off.
Clean Button
It can be used when the unit is not in the Ice Making mode.
It can be used for defrosting, flushing, descaling or sanitizing process.
 Press and hold for 3 seconds to start Cleaning, the Cleaning LED flashes
slowly while the unit is currently in cleaning process.
 Press and hold for 3 seconds again to stop Cleaning, the Cleaning LED goes
off.