Flurida FDFM1JA01 - Dispenser Care; How to drain water; How to empty the ice bin and water reservoir; If the Water Level red LED flashes and the unit stops making ice

11
24412 Main St. Suite 105, Carson, CA 90745
DISPENSER CARE
CAUTION
Use food grade citric acid powder and chlorine bleach only.
Follow the product instructions carefully for First Aid.
Keep them out of reach of children.
1-How to drain water
 Unplug the unit.
 Pull the drain tubes with plugs/holders out of the unit back and lower
them to a bucket or sink, remove the plugs/holders to release water.
 Replace the plugs/holders and put the tubes with plugs/holders back to
the unit.
2-How to empty the ice bin and water reservoir
 Dispense ice until no more ice comes out of the ice dispense point.
 Unplug the unit and let the remaining ice melt.
 Drain water following instructions in Section 1.
3-If the Water Level red LED flashes and the unit stops making ice
 Fill the water reservoir with clean potable water.
4-If the Water Level red LED illuminates but the water reservoir is full
 Unplug the unit and plug the unit into power again.
5-If the Cleaning LED flashes and the unit stops making ice (If this
section can’t solve your problem, please go to section 9)
 Empty the ice bin and water reservoir following instructions in Section 2.
 Plug the unit into power.
 Fill the water reservoir with clean potable water.
 Press and hold Clean button for 3 seconds to start the Cleaning mode for
defrosting process.
 Drain water following instructions in Section 1.
 Plug the unit into power
 Fill the water reservoir with clean potable water.
 Press Make Nuggets button once to start making ice.
6-If the Making Ice green LED illuminates but the unit has dispensed
all ice
 (Press and hold Make Nuggets button for 3 seconds to exit the Ice
Making mode first).