Flurida FDFM1JA01 - If ice is stuck or jammed and the unit cant dispense ice; How to flush the unit once a week to prevent high water TDS and hardness; How to descale the unit with citric acid once a month to prevent sediment building up; How to sanitize the unit with chlorine bleach once a month to prevent bacteria growing

1
2
12
i n f o @ f l u r i d a a p p l i a n c e s . c o m
 Press and hold Clean button for 3 seconds to start the Cleaning mode to
melt the clumped ice that blocks the infrared beam. Press and hold
Clean button again for 3 seconds in 1 minute to stop.
 Then press Make Nuggets button once to start making ice.
7-If ice is stuck or jammed and the unit can’t dispense ice
 Remove the stuck ice in the dispense point with a spoon.
 Or break the jammed ice by pressing Clean button while you hold
Dispense Nuggets button.
 Then press and hold Dispense Nuggets button to dispense ice.
8-How to flush the unit once a week to prevent high water TDS and
hardness
 Empty the ice bin and water reservoir following instructions in Section 2.
 Fill the water reservoir with clean potable water to MAX WATER FILL.
 Plug the unit into power.
 Press and hold Clean button for 3 seconds to start Cleaning mode for
flushing process.
 Drain water following instructions in Section 1 when the flushing process
is complete (the Cleaning LED goes off).
9-How to descale the unit with citric acid once a month to prevent
sediment building up
 Empty the ice bin and water reservoir following instructions in Section 2.
 Mix 15 teaspoons of food grade citric acid powder with 100 fl oz potable
water to make descaling solution.
 Fill the water reservoir with the descaling solution to MAX WATER FILL.
 Plug the unit into power.
 Press and hold Clean button for 3 seconds to start Cleaning mode for
descaling process.
 Drain water following instructions in Section 1 when the descaling
process is complete (the Cleaning LED goes off).
 Plug the unit into power.
 Fill the water reservoir with clean potable water again.
 Press and hold Clean button for 3 seconds to start Cleaning mode for
rinse process. Press and hold Clean button again for 3 seconds in 5
minutes to stop rinsing.
 Drain water following instructions in Section 1.
 Repeat the rinse process 3 times until water is clean and tasting good.
10-How to sanitize the unit with chlorine bleach once a month to
prevent bacteria growing
 Empty the ice bin and water reservoir following instructions in Section 2.