EasyManua.ls Logo

Flurida FDFM1JA01 - If you are away on holidays or vacations; Normal Operating Sounds

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
24412 Main St. Suite 105, Carson, CA 90745
Mix 1 teaspoon of 5% food grade chlorine bleach with 100 fl oz clean
potable water to make sanitizing solution.
Fill the water reservoir with the sanitizing solution to MAX WATER FILL.
Plug the unit into power.
Press and hold Clean button for 3 seconds to start Cleaning mode for
sanitizing process.
Drain water following instructions in Section 1 when the sanitizing
process is complete (the Cleaning LED goes off).
Plug the unit into power.
Fill the water reservoir with clean potable water again.
Press and hold Clean button for 3 seconds to start Cleaning mode for
rinse process. Press and hold Clean button again for 3 seconds in 5
minutes to stop rinsing.
Drain water following instructions in Section 1.
Repeat the rinse process 3 times until water is clean and tasting good.
11-If you are away on holidays or vacations
Empty the ice bin and water reservoir following instructions in Section 2.
12-You may hear the following normal operating sounds
You may hear a boiling, rattling or gurgling sound produced by flow of
refrigerant through the evaporator.
You may hear air being forced through the condenser by the condenser
fan.
You may hear a clicking sound produced by the refrigerant valve or
water valve.
You may hear a high pitched hum or pulsating sound produced by the
compressor.
You may hear a high pitched sound produced by the gear motor.
You may hear ice being ejected from the ice engine to the ice bin.

Other manuals for Flurida FDFM1JA01

Related product manuals