Flurida FDFM1JA01 - First Time Use; Filling the water reservoir for the first time use; Flushing the unit for the first time use

7
24412 Main St. Suite 105, Carson, CA 90745
LED illuminates when the unit is plugged into power.
Red LED flashes when more water is needed.
Green LED illuminates once water is full.
Blue LED flashes slowly while the unit is currently making ice.
Green LED illuminates once the ice bin is full.
LED flashes slowly while the unit is currently in cleaning process.
LED flashes quickly once cleaning is needed for defrosting process.
FIRST TIME USE
For the first time use flush the unit following instructions below.
For the first time use dispense several cups of ice and then discard
them.
1. Filling the water reservoir for the first time use
 Remove the reservoir door by pulling its two sides outwards.
 Add potable water to MAX WATER FILL.
 Replace the magnetically attached door.
2. Flushing the unit for the first time use
 Plug the unit into power.
 Press and hold Clean button for 3 seconds to start the Cleaning mode for
flushing process.