Flurida FDFM1JA01 - Dispensing Ice; Combination Buttons; Cleaning the pump protector

9
24412 Main St. Suite 105, Carson, CA 90745
 Push the fill port door to open.
 Add potable water until the Water Level green LED illuminates with 5
beeps.
 Release the fill port door to close.
Or
 Add potable water between MAX WATER FILL and MIN WATER FILL.
Dispensing Ice
NOTE
The unit does not dispense ice while Cleaning LED flashes.
Dispense Nuggets button
The unit will stop dispensing automatically after 60 seconds elapse.
 Place a cup under the ice dispense point.
 Press and hold to dispense ice, release to stop.
Combination Buttons
It can be used when the unit can’t dispense ice because ice is jammed.
 While you hold Dispense Nuggets button, press and hold Clean button to
turn the ice auger backwards.
Cleaning the pump protector
 Drain water following instructions in Section 2.
 Remove the water reservoir door and lift up the pump protector.
 Clean the pump protector with dishwashing liquid and rinse it with
potable water.
 Replace the pump protector