6
1. With the cover removed, fill the Power Filter case completely with water
and replace cover.
2. For the initial start-up and for a faster priming of the filter, adjust water flow control
lever on the intake “U” tube to its minimum position.
3. Plug power cord into electrical outlet. Allow a few seconds for priming
(air being expelled from the “U” tube.)
4. After priming has been completed, move adjustment control on “U” tube to adjust
water flow rate to desired output level.
(See How it Works — Patented Refiltration System.)
IMPORTANT: DO NOT OPERATE FILTER WITHOUT WATER.
For a correct filter installation, the minimum water level in the tank should be no more
than 6 cm (2.25 inches) below the aquarium rim. NOTE: For maximum filter operation
and efficiency, regular cleaning of media is recommended every two weeks.
POWER FILTER START-UP
maximumminimum
To Next Page
Loading...
