Fluval FX UVC - Whats Included; Components Overview; Important Safety Instructions; Read and Follow All Safety Instructions

0.25" / 1 cm
BB
AA
12.Attachrubberelbowadaptertolter
output valve and secure clamp by
tightening it with screwdriver.
13.Doublecheckallmetalclampsare
positioned approx. 0.25"/ 1 cm from
ends and are tightly secured with a
screwdriver to ensure watertight seal.
12
14
16
13
14.OpenlterINandOUTvalves
and wait 15 minutes to ensure
connections are watertight.
15.PluginFXltertoelectricaloutlet.
The electronic automatic priming
  sequencewillbegin.
16.Ensurewaterisowingoutfromlter.
  Oncecompleted,connectpower
supply to UVC unit and plug into
electrical outlet. A light indicator
(visible through the semi-transparent
lamp cover) will show that the UVC
unit is operating.
INSTALLATION ON CABINET WALL
WITH FLUVAL FX2/FX4/FX6 FILTER
IMPORTANT:
 •Thisinstallationoptionrequiresone1"/25mmFXhoseforcabinetmount
  (soldseparately–#A20233)orequivalent1"/25mminnerdiametervinylhose
  (soldseparately).
 •Self-tappingscrewssuppliedwithUVCunitaresuitableforwoodencabinet
  wallswithaminimumthicknessof0.6"/15mm.Installationisnot
  recommendedonmovingelements(i.e.cabinetdoors).
 •UVCmustbeconnectedtolteroutputhosingonly.NeverinstallUVC
  tolterintakehosing.
 •EnsureUVCandhosingarealwayspositionedaboveFXltercover.
1. ToprepareFXlterforUVCinstallation,referto
the Preparing Your Filter section (steps 1-7).
2. Select desired UVC location on cabinet wall.
3. Usingascrewdriver,axmountingbracket
to cabinet wall using screw holes (A) for
 horizontalpositioning,orholes(B)for
vertical positioning.
IMPORTANT:Ifinstallinghorizontally,ensuremountingbracketisplacedsothat
thescrewholesappearbelowtheFluvallogo.
3 VERTICAL3 HORIZONTAL
3