Fluval G6 User Manual

HYDRO TECH PERFORMANCE MONITOR
ADVANCED FILTRATION SYSTEM
www.fluval-g.com
EN.16
GRAPHIC DISPLAYS
These display screens have no variable settings, but
supply crucial information for your filter.
FILTER FLOW GRAPH
shows the approximate
owrateoverthelast
48 days.
TEMPERATURE GRAPH
shows the temperature
trend over the last
8 days of operation.
CONDUCTIVITY GRAPH
represents the conduc-
tivity trend over the last
48 days.
ALARMS & WARNING MESSAGES
The “G” series software continuously monitors filter
operations and will provide “Alert” signals for some
abnormal conditions. It also displays reminders
about scheduled maintenance. When warnings or
alerts are displayed they will alternate with the Main
Screen. If there is more than one warning message
to display, the system will display one message in
order of priority.
#1 PRIORITY
Sensing air in filter
This message appears
when there is not
enough water in the
filter.
For further instructions visit www.fluval-g.com.
#2 PRIORITY
Blocked Impeller.
This message appears
when the impeller is
blocked, and the filter is
not pumping water.
For further instructions visit www.fluval-g.com.
#3 PRIORITY
Alert Temperature
This message appears
when the aquarium
water temperature is
outside the set range.
For further instructions visit www.fluval-g.com.
#4 PRIORITY
Alert Conductivity.
This message appears
when the aquarium
water conductivity is
outside the set range.
For further instructions visit www.fluval-g.com.
#5 PRIORITY Low Flow.
This message appears
whenthewaterow
is equal or below the
factory-set minimum.
For further instructions visit www.fluval-g.com.

Fluval G6 Specifications

General

Filter Type	Canister
Mechanical Stage	Yes
Biological Stage	Yes
Chemical Stage	Yes
Display	LCD
Self Priming	Yes
Smart Pump Monitoring	Yes
Number of Media Trays	4
Voltage	120 V
Frequency	60 Hz
Aquarium Capacity	Up to 600 L (160 US Gal)
Filter Volume	6.6 L (1.7 US Gal)
Hose Diameter	19 mm (0.75 in)