10
TROUBLESHOOTING
If an LED Strip Light does not turn on, please proceed as follows:
LED STRIP LIGHTS AND TANK MAINTENANCE
CLEANING THE LED STRIP LIGHTS
Disconnect the plug of all the electrical equipment from power supply before any maintenance operation.
WARNING: Be sure you unplug the LED drivers from the power outlet; just switching o the lights with the APP is NOT enough because it does not stop the power supply.
Never place the LED Strip Lights under water jets or submerge in water.
For maximum LED performance, it is recommended that the xtures and LED lens be cleaned on a weekly basis. Unplug the LED drivers prior to cleaning the light xtures. Use
both hands when manipulating these appliances. Wipe exposed surfaces carefully with a damp cloth to remove any dust or mineral deposits that may collect over time. Do not
use detergents or harsh cleaners as it can damage the light xtures.
Use Fluval LED Lens Cleaning Kit (A3969) to clean the LED portion of the light xtures. Make sure all surfaces are dry before re-connecting the LED drivers to the power source.
No special maintenance is required for the Fluval LED Strip Lights and covers, other than periodic cleaning with a damp cloth (never use harsh chemical products or detergents).
To remove calcareous deposits, it is recommended to use a mild acid such as lemon juice, followed by a thorough wipe down with a damp cloth to remove any residue.
SALTWATER AQUARIUMS
It is commonly known that saltwater is far more corrosive, conductive (of electricity) and generally degrades both plastic and metal parts at an accelerated rate versus fresh
water. To minimize salt accumulations on the Fluval Covers and on the LED Strip Lights, it is recommended to take note of the following helpful tips:
1. Make sure lter outputs do not spray above the water surface; position them below the water surface with a slight downward angle,
but still allow for surface movement (contributes to oxygenation).
2. If an air pump must be used, frequent removal of salt deposits will be necessary.
3. Keep the water level as constant as possible (regular top-ups due to evaporation). This is benecial in providing stable salinity and will help protect the cover.
4. It is recommended to regularly clean all LED Strip Light components that come into contact with saltwater on a weekly basis. The cleaning should be carried out with
a wet cloth (never use harsh chemical products or detergents). Simple lemon juice may be used to take away salt accumulation. Afterwards, rinse carefully to eliminate
every residue of acid.
FLUVAL SIENA LED STRIP LIGHTS SPECIFICATIONS
Aquarium Model SIENA 166 SIENA 272 SIENA 332
LED STRIP LIGHT UNIT BT LED UNIT SIENA BT LED UNIT SIENA BT LED UNIT SIENA
LED STRIP LIGHT MODEL NUMBER A13253 A13254 A13255
LUMINAIRE WATTAGE 2 x 22W 2 x 36W 2 x 48W
LUMENS 2 x 2000 lm 2 x 3300 lm 2 x 4400 lm
LUMINAIRE OPERATING VOLTAGE 24Vdc 24Vdc 24Vdc
LED DRIVER TYPE (x 2) S024AM[X]2400100 S040Q[X]2400150 S050F[X]2400200
LED DRIVER INPUT VOLTAGE 100-240Vac 100-240Vac 100-240Vac
X= B For UK Plug X= V For EU Plug X= U For US Plug X= S For AUS Plug
PROBLEM CAUSE SOLUTION
The light isn’t working.
Missing connection of the LED driver
to the power outlet.
Connect the LED driver to the power outlet.
Missing connection of the lighting unit
to the LED driver.
Connect the lighting unit to the LED driver
with its connector.
If the problem is not solved after following the above, please contact your Hagen retailer.
To Next Page
Loading...
