Place the clamp onto the smaller end of the vent hose and thread
through to the larger end. Place the larger end of the vent hose into
the exhaust port. Tighten the clamp using the provided double head
wrench until the vent hose is secure.
Turn on the machine by pressing the power button. The first startup
may take up to two minutes.
Follow the machine prompts. Please refer to【Connection Settings】in
the “HEXA user manual” for other connection methods. Make sure the
machine and any connected devices are on the same local area
network.
04
3.
4.
* Before engraving, you must select the language and network on the
machine. You must also download and set up the software in order to pair the
computer and the machine.
Quick Guide (English)
2.
To Next Page
Loading...
