14
LCD Screen:
Instructions
To start the computer press and hold the “MODE” button for 1.5
seconds. Once this is done the “Power Level” section of the screen will
display the current level of pedal assist active. Default is 0, and
maximum is 5. The level of pedal assist can be adjusted by pressing the
“UP” or “DOWN” buttons as appropriate. When active the throttle will
also be active, and this can be triggered regardless of the level of pedal
assist by depressing the throttle lever found on the right-hand grip of
the handlebars.
Additionally a walk-assist mode can be activated by pressing
“DOWN” for 2.5 seconds. This is a single-speed designed to be an
average walking pace, NOT FOR RIDING.
When full, the “Battery Indicator” will show 5 segments, when the
battery is low there will be one segment, and to indicate that it needs
to be charged the segment will flash at 1Hz.
The headlight, taillight and backlight on the LCD screen can be
activated by pressing the “UP” and “MODE” buttons for 3 seconds,
similarly it can be turned off by holding the “UP” and “MODE” buttons
for 3 seconds. For USB charging, insert the USB cable into the display
before turning the display on to activate USB charging mode.
To Next Page
Loading...
