Fly Fly Hobby FF-D005 User Manual

1 pc required
800mm
1. Signal cable
(Throttle)
4. Silicone Battery cable (No. 12AWG or 14AWG)
800mm
1 pc required
2 pcs required
800mm
3. Signal cable
(Alieron)
F-86 SABRE
Scale EDF Radio Control model airplane
Model No : FF-D005
UNDER SAFETY PRECAUTIONS
This radio control is not a toy!
- Always keep this instruction manual ready on hand for quick reference.
- Assemble this kit only places out of children reach.
- First-time builders of EDF model should seek the advice of experienced modellers before
beginning assembly and if they do not fully understand any parts of the construction.
- Taking out liability insurance is recommended.
- You are responsible for this model’s assembly and safe operation.
Wingspan : 1420mm
You need to purchase the following accessories separately to complete the assembly.
2 pcs required
800mm
2. Signal cable
(Elevator)
1 pc required
5. 60A Electric Speed Control (ESC) w/BEC
60A
w/ BEC
1 pc required
6. B36 Brushless Motor, 1600-1800kv,
Shaft dia 5mm
5 pcs required
7. Micro servo, 8g, torque >1.0kg
1 pc required
8. Li-Po Battery, 5-cells (18.5v), 3600mAh, 20C
Copyright 2007 Fly Fly Hobby
Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com
C

Fly Fly Hobby FF-D005 Specifications

General

Brand	Fly Fly Hobby
Model	FF-D005
Category	Toy
Language	English

Summary

F-86 Sabre RC Model Introduction and Safety

Safety Precautions for RC Model Operation

Essential safety guidelines and warnings for handling the RC model.

Required Accessories for Assembly

List of accessories that must be purchased separately for assembly.

Kit Contents and Required Tools

Included Kit Components Overview

Detailed list and diagrams of all parts included in the model kit.

Tools Needed for Construction

List of necessary tools for building the RC airplane.

F-86 Sabre Aircraft Assembly

Horizontal Tail and Fuselage Assembly

Assemble the horizontal tail and begin fuselage construction.

Fuselage and Nose Gear Attachment

Complete fuselage assembly and attach the nose gear.

Fan Unit and ESC Installation

Install the ducted fan unit and Electronic Speed Controller (ESC).

Wing and Fin Construction

Construct the wings and assemble the aircraft fins.

Final Adjustments and Flight Preparation

Control Surface and Dimensional Adjustments

Adjustments for control surfaces and overall aircraft dimensions.

Center of Gravity (CG) Balancing Procedure

Procedure for checking and achieving the correct Center of Gravity (CG).