Fly Wing UH-1 - Flight Modes and Return Functions; 3 D Mode Takeoff; Home Mode Operations; Stopping Low Power Return

使用您的PHANTOM 3 Advanced
3. 检查电量
请分别短按一次遥控器和智能飞行电池的电源开关以检查电量。首次使用智能飞行电池，请务必充满电。
短按一次、再长按2秒遥控器电源开关可开启遥控器（重复本操作可关闭遥控器）。
短按一次、再长按2秒智能飞行电池开关可开启智能飞行电池（重复本操作可关闭智能飞行电池）。
●
推荐在平板设备上使用DJI GO App以获得最佳的体验。DJI GO App要求使用iOS 8.0及以上系统和Android 4.1.2及以上系统。
1. 下载 DJI GO App
安装 DJI GO App，请在软件商店或扫描下方二维码下载。
或用移动设备访问以下网址：http://m.dji.net/djigo
2. 观看入门教学视频
扫描二维码观看扫描二维码下载安装
低 高
电量
使用Phantom 3 Advanced 之前，请 在 DJI GO App 或者 DJI 官方网站产品页面完整观看教学视频与下载阅读
《Phantom 3 Advanced 用户手册》，并仔细阅读以下包装内文档：《Phantom 3 Advanced 快速入门指南》、
《Phantom 3 免责声明和安全操作指引》、《Phantom 3 智能飞行电池安全使用指引》和《物品清单》。
4.充电
●
请使用 DJI 官方提供的充电器充电。充电前需将智能飞行电池取出。
●
连接充电器到交流电源（100~240 V，50/60 Hz；如需要请使用电源转换插头）。
●
智能飞行电池、遥控器开启或关闭的状态下均可充电。建议在关闭状态下充电。
●
在关闭状态下充电时，智能飞行电池与遥控器指示灯全部熄灭表示电已充满。
B
A
B
A
取出智能飞行电池
低 高
电量
请在 DJI GO App 或访问DJI官方网站观看。
http://www.dji.com/cn/product/phantom-3/video
www.dji.com
ADVANCED
PHANTOM 3
bout the use of fully manual 󶊆 mode.
When the helicopter is flying in the air, switch from  mode switch to 󶊆 mode, the helicopter will
fall down uickly. If you are a novice, it is very dangerous to operate this function, and the helicopter
will crash. xperienced pilots can uickly and manually increase pitch control after switching to 󶊆
mode.
● nlock  take off in 󶊆 mode take mode 󶊅 as an example
1󵼾ial the motor run switch to stop position, dial the
mode switch to 󶊆 position,
󶊅󵼾ove the helicopter to the outdoor open
environment without trees and buildings.
ower on, and the H1 flight control light is solid
blue.
󶊆󵼾nlock as shown in the figure and hold
for about 󶊈 seconds until the flight control
light is
flashing blue.
󶊇󵼾uring the blue light is flashing, ial motor
switch stick to run position,and the helicopter
motor will run. ush throttle stick upwards to take
off.
󶆋. Home ode
If you need to use the home mode one key to return, low power return, please make sure that the 
satellite signal is good before takeoff, and there are no buildings or trees around the takeoff point that
hinder the return.
● mart return
ial the switch to H,the helicopter return automatically. Then dial to  mode to terminate the
return flight.
• ow power return when the power system judges that the current power is low, it will auto return
and land. lease ensure that the current distance of the helicopter conforms to the range of the
helicopters remaining power.
• When returning with low power, the helicopter will auto rise up to 1󶊈 meters, and then return,
which isnt controlled by the operator. If there are obstacles trees or buildings on the way back,
the auto flight needs to be terminated
● Ways to stop low power
• If you want to stop the low power return, please flick the switch to H, and then flick the switch
to . You can manually control the helicopter after landing and manually turn off the motor.
uring this period, the helicopter will not return with low power until the helicopter is powered off.