23
ADJUSTING HANDLEBAR ROTATIONAL POSITION
Following any adjustment of the handlebar stem angle, the handle bar rotational
position should also be adjusted. Ensuring that the handgrips and brake levers are
in the correct position will avoid any strain or discomfort while riding.
A. Using the provided 4mm allen wrench, loosen the four stem clamp bolts.
B. Rotate the handlebar until the preferred position is achieved checking to ensure
the handlebar is centered left-to-right within the stem clamp.
C. Evenly tighten the bolts to 6 to 8 Nm using a torque wrench.
A
B
C
To Next Page
Loading...
