8
Getting Started
ASSEMBLY INSTRUCTIONS
The following steps provide a general overview of the assembly process for
your eBike. It is recommended to consult a professional bicycle mechanic for
assistance with your eBike’s assembly, maintenance, and repair.
Visit flyer.radioflyer.com or contact customerservice@radioflyer.com for
additional assistance assembling, using, repairing or maintaining your eBike.
WARNING! Incorrect assembly, maintenance, or use of your Flyer™ eBike can cause
component failure, loss of control, serious injury, or death. Please note, the assembly
and first fit of your Flyer™ eBike require special tools and mechanical skills. It is highly
recommended that the assembly and adjustment are completed by a reputable bicycle
mechanic when possible.
The following items are required for assembly:
• 5mm allen wrench (included)
• 4mm allen wrench (included)
• 15mm open-ended wrench (included)
• Scissors or flat-sided cutters
Step 1: Unpack your bike
Remove the bike from the outer carton and set it on a flat, clean surface. Deploy
the kickstand and place the bike upright, resting on the kickstand and rear wheel.
Remove all protective packaging material and carefully cut all zip-ties to avoid
damaging the paint. Verify that you have all of the components listed below.
Contact Radio Flyer Customer Service if any components are missing.
• Front Wheel
• Front Fender
• Pedals
• Headlight
• Running Boards (Left & Right)
• Charger
• Tool Kit
• Keys
• Steering Assist Spring
• Tire pump
• Pedal grease (recommended)
• Torque wrench (recommended)
To Next Page
Loading...
