33
Seat
• Ensure the seat is securely connected to the eBike and the seat
cannot be moved.
• Confirm the adjustment lever is fully tightened and locked.
• Verify the seat is properly adjusted to fit your height.
• Confirm that the seat is securely fastened to the post (torque: 10 Nm).
Handlebar
• Confirm the handlebar always aligns with fork when moving in desired
direction and both parts turn in unison.
• Ensure the steering spring is connected on both ends with no
interference from cables.
• Secure the front wheel or fork, preventing it from turning. Apply
approximately 20 lbs of force to one of the handlebar grips. The
handlebar should not rotate independently from the front wheel or
fork.
• Confirm the stem clamp bolts are tightened to 6 Nm and the stem
faceplate bolts are tightened to 6 to 8 Nm.
Chain
• Ensure the chain is properly lubricated and runs smoothly.
• After using in rough weather conditions such as rain, snow, or other
severe weather, verify that chain and links are clean and undamaged.
• Confirm the chain tension mechanism is in line with the pedal
assembly and derailleur.
Bearings
• Verify all bearings are lubricated and run smoothly with no unnatural
sounds such as grinding or rattling.
• Check the bearings in the headset assembly, pedals and bottom
bracket, and the rear wheel.
Cranks & Pedals
• Confirm pedals are tightly secured to the cranks (torque: 35Nm)
and the crank is tightly secured to the bottom bracket spindle
(torque: 40Nm).
• Verify cranks are parallel to the downtube and not bent.
Frame & Fork
• Confirm there is no damage or bending to the front fork and frame
and that fork is parallel with the front tire.
Motor Drive
Assembly &
Throttle
• Confirm that none of the spokes securing the hub motor are broken or loose.
• Verify that the brake disc is secured to the hub motor and all screws are tight.
• Turn on display before ride to confirm all features are working correctly.
• Ensure the throttle functions properly.
Battery
• Always charge the battery before each use.
• Confirm there is no damage to the battery.
• Ensure the battery is always securely locked to the frame with the
keys removed.
Control Cables
• Confirm all cables are routed away from moving parts and allow the
headset to rotate freely.
• Confirm cables, housings, and electrical connectors are undamaged
and free of debris and liquids.
• Verify the headlight, taillight, and brake light are connected and
functioning properly.
Accessories
• Ensure that any loads or accessories do not interfere with moving
parts.
• Tighten and secure all accessories and accessory components.
• Ensure rider is wearing a helmet and the helmet is not damaged.
Reflectors
• Verify reflectors are adjusted and outward facing before all rides.
• Ensure that loads or accessories do not interfere with reflectors.
To Next Page
Loading...
