flyfly hobby DG-808S User Manual

Model No : FF-B013 / 015-E
Scale Radio Control model airplane
Wingspan : 4000mm
UNDER SAFETY PRECAUTIONS
This radio control is not a toy!
- Always keep this instruction manual ready on hand for quick reference.
- Assemble this kit only places out of children reach.
- First-time builders of large scale model should seek the advice of experienced modellers
before beginning assembly and if they do not fully understand any parts of the construction.
- Taking out liability insurance is recommended.
- You are responsible for this model’s assembly and safe operation.
1 pc required
1. Signal cable
(Elevator)
You need to purchase the following accessories separately to complete the model.
4 pcs required
1500mm
5 pcs required
3. Micro servo, torque >1.8kg
1 pc required
4. Standard servo, torque >3.0kg
C
Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com
FLYFLY
HOBBY
2. Signal cable
(Aileron, flap)
1000mm

flyfly hobby DG-808S Specifications

General

Brand	flyfly hobby
Model	DG-808S
Category	Toy
Language	English

Summary

Safety Precautions

General Safety Advice

Important safety guidelines for operating the radio-controlled model.

Required Accessories

List of additional components needed to complete the model assembly.

Important Warnings

Pre-flight and Operation Safety

Warnings for novice pilots and electric-motor powered aircraft operation.

Kit Contents and Tools

Main Components List

Overview of the primary parts included in the model kit.

Required Tools and Batteries

List of tools and batteries necessary for assembly and operation.

Wing Assembly

Attaching Wing Sections

Instructions for joining and securing the main wing parts.

Securing Wing Tips

Method for attaching and reinforcing the wing tips.

Fuselage Assembly

Connecting Wings to Fuselage

Procedure for attaching the wings to the main fuselage body.

Securing Fuselage Components

Steps for attaching internal components and canopy to the fuselage.

Elevator Assembly and Alignment

Attaching Elevator to Tail

Instructions for mounting the elevator control surface to the tail fin.

Tail Alignment Check

Procedure to ensure the tail fin is correctly aligned with the fuselage.

Final Adjustments and Settings

Control Surface Alignment

Checking and adjusting the symmetry of control surfaces.

Control Throws and CG

Setting correct control surface throws and verifying the center of gravity.

Motor Installation

Motor and Propeller Setup

Details on selecting and preparing the motor and propeller.

Mounting the Motor

Procedure for securely attaching the motor to the model.