5. Reset and Fail Safe mode
If for any reason your Vario LS becomes unresponsive or does not boot
up, please try the following procedures.
1. Reset the Vario LS
Insert a paper clip into the reset hole and push it gently. Do not use
extreme force or use a sharp tip tool to do this operation.
2 . Put the Vario LS into “fail safe” mode: keep the Power/Menu button
pressed, while pressing the reset button. Keep the Power/Menu button
pressed untill a counter is displayed on the screen. After the counter
ends the Vario LS shoud display “SAFE” text on the graphic area. The
firmware can now be installed by using manual update (chapter 4), or,
exit the “fail safe mode”, pressing the reset button again.
To Next Page
Loading...
