5. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Loosen the wing knobs to enable the handles to be
folded over the product.
2. Store the lawnmower in a dry, enclosed and frost-free
place.
At the end of the mowing season:
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Make sure that the electric cable is stored correctly to
prevent damage.
Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to normal
household waste. It must be disposed of in line
with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal
recycling collection centre.
6. TROUBLESHOOTING
DANGER! Risk of physical injury!
Cut injury when the blade turns or the
product starts accidentally.
v Wait for the blade to stop, disconnect the
product from the mains and use gloves before
you do troubleshooting.
Fails to Operate
1. Is the correct Starting procedure being followed?
See 3. OPERATION To start the lawnmower.
2. Is the power turned on?
3. Check the fuse in the plug, if blown replace.
v Fuse continues to blow? Immediately disconnect
from the mains electricity supply and consult your
local approved Service Centre.
Poor Grass Collection
1. Disconnect from the mains electricity supply.
2. Clean the outside of the air intakes, the discharge chute
and the underside of the deck.
3. Raise to a higher height of cut.
See 3. OPERATION To adjust the cutting height.
v If poor collection persists. Immediately disconnect
from the mains electricity supply and consult your
local approved Service Centre.
Excessive Vibration
1. Disconnect from the mains electricity supply.
2. Check that the blade is fitted correctly?
3. If the blade is damaged or worn, replace it with a new
one.
v If vibration persists? Immediately disconnect from
the mains electricity supply and consult your local
approved Service Centre.
Lawnmower becomes heavy to push
1. Disconnect from the mains electricity supply.
2. In long grass or uneven ground, the height of cut should
be raised to a higher position.
See 3. OPERATION To adjust the cutting height.
3. Check that the wheels and rollers can rotate freely.
v If problem persists? Immediately disconnect from
the mains electricity supply and consult your local
approved Service Centre.
NOTE: For any other malfunctions please
contact the Husqvarna UK Ltd. Customer
Service. Repairs must only be done by
Husqvarna UK Ltd. service departments or special-
ist dealers approved by FLYMO.
Electric lawnmower Unit Value
(CN32)
Rated Power kW 1.0
Mains voltage V 230
Mains frequency Hz 50
Speed of rotation cutting blade R/min. 3,600
7. TECHNICAL DATA
10
21032-85.960.01.indd 1021032-85.960.01.indd 10 20.09.21 14:2820.09.21 14:28
To Next Page
Loading...
