CAUTION! Do not overload your mower.
Mowing long thick grass may cause the motor speed to
drop. You will hear a change in the motor sound. If the
motor speed drops, you may overload your lawnmower
which may cause damage. When mowing in long thick
grass, a rst cut with the cutting height set higher will help
reduce the load. See “Adjusting the Cutting Height”.
GRASSBOX
For optimum performance your product is designed to be
used with the grassbox tted.
Emptying the Grassbox (K)
Stop the product and wait until the cutting head has
stopped rotating before emptying the grassbox.
1. Lift the grassbox lid.
2. Lift the grassbox off the product and empty.
3. Replace grassbox and lid carefully.
Failure to t the grassbox and lid correctly will cause poor
collection of grass clippings.
CARING FOR YOUR PRODUCT
Cleaning (P)
NOTE: Use gloves.
It is very important that you keep your lawnmower clean.
Grass clippings left in any of the air intakes or under the
hood could become a potential re hazard.
1. Remove grass from under the hood with spanner/
scraper tool.
2. Using a soft brush, remove grass clippings from all air
intakes.
3. Remove the blade to gain access to the fan and clean
with a soft brush.
4. Wipe over the surface of your lawnmower with a dry
cloth.
IMPORTANT: Never use water for cleaning your
lawnmower. Do not clean with chemicals, including
petrol, or solvents. Some can destroy critical plastic
parts.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Ask your local Service Centre to clean the air lter
thoroughly and carry out any service or repairs
required.
4. Make sure that the electric cable is coiled properly.
Carrying your Lawnmower
Ensure the blade is facing away from you.
Storing your Lawnmower
Store in a dry place where your lawnmower is protected
from damage.
TROUBLESHOOTING
Fails to Operate
• Is the power turned on?
• Check the fuse in the plug. Replace if blown.
• Fuse continues to blow? Immediately disconnect from
the mains electricity supply and consult your local
approved Service Centre
• Is the correct starting procedure being followed?
Poor Flotation
• Disconnect from the mains electricity supply.
• Clean the underside of the hood and the fan blades.
• Raise to a higher height of cut. See “Adjusting the
Cutting Height”.
• If poor otation persists? Disconnect from the mains
electricity supply and consult your local approved
Service Centre.
Poor Grass Collection
NOTE: Disconnect from the mains electricity supply.
• Is the grassbox tted correctly?
• Are you using in straight lines?
• Are you cutting more than one third of the grass length?
• Do you need to raise the cutting height?
• Follow the procedure described in “Poor Flotation”.
Excessive Vibration
NOTE: Disconnect from the mains electricity supply.
• Replace broken or missing plastic cutters.
• Check plastic cutters are tted correctly.
• If vibration persists? Immediately disconnect from the
mains electricity supply and consult your local approved
Service Centre.
SERVICE RECOMMENDATIONS
• Your product is uniquely identied by a silver and black
product rating label.
• We strongly recommend that your product is serviced at
least every twelve months, preferably by a professional.
8
To Next Page
Loading...
Need help?
General
