Fault Finding Chart
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT CHECK ACTION
Is the automatic line feed work-
ing?
Manually feed out line.
SEE “MANUAL LINE FEED”
Is the line fed out and visible?
Has line been removed from
cleat?
Remove cap and spool, free line
and re-fit spool and cap. SEE
“CUTTING HEAD”
The line may be jammed on the
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Is the manual line feed working?
Has too much line been fed out?
SEE “MANUAL LINE FEED”
Contact your local approved Serv-
ice Centre or Husqvarna UK Ltd.
Customer Service.
Is the line cutter missing from the
safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK 1800 882 350 ROI
No
No
No
Yes
Yes
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS CLATTER-
ING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT P ERSISTS
Has the motor reached full speed
before use?
No
Allow the motor to reach full speed
before use.
Are you using the trimmer cor-
rectly?
?
Only use tip of nylon line to trim.
SEE “How to trim and edge”
Is the line jamming on the spool?
Yes
Rewind the line on the spool, if
symptoms still persist, change
spool and line.
V
Clean wheel and groove on trimmer head. SEE “MAINTENANCE”
WHEEL STOPS TURNING
X
W
4. Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with a
soft brush (V & W).
5. Attach wheel as described in Wheel Assembly.
6. Inspect the trimmer carefully, especially the parts of
the cutting head.
7. If your trimmer is damaged in any way contact your
local Husqvarna UK Ltd. approved service centre.
• Never use a damaged trimmer.
Cable Storage
1. Your mains cable can be stored on the product as illus-
trated in Fig X1.
2. Wind cable carefully to avoid kinking.
• Store in a cool, dry place and out of reach of children.
Do not store outdoors.
To Next Page
Loading...
